Not everyone has proper brake line tools. As a result this can make doing an installation of a disc brake conversion kit a bit frustrating. It can lead to challenges in getting the lines routed properly to valve locations and connection ports. The lack of the proper tools can also lead to a look that's less than desirable.

Many of you have mentioned that having a hard line set would make life a lot easier when doing a disc brake conversion. So we listened and we are very proud to introduce our very first hard line kit. What makes our hard lines unique is that they are not a reproduction. These lines are specifically made for 1964-1966 ford mustangs using Master Power Brakes products.

The Hard Line Kit for 64-66 Mustangs consists of the following: 

Front to Rear 3/16" Stainless Steel Hard Line (9/16"-20 Tube Nut at the valve and 3/8"-24 Tube Nut at the rear hose)

RH 3/16" Stainless Steel Hard Line (3/8"-24 Tube Nut at the valve and 3/8"-24 Tube Nut at the Front Brake Hose)

LH 3/16" Stainless Steel Hard Line (3/8"-24 Tube Nut at the valve and 3/8"-24 Tube Nut at the Front Brake Hose)

How easy is this line kit to install? Check out the video below for more information.

 You can find our new hard line kit for 1964-1966 Mustang's by Clicking Here. 

We hope that you found this article useful. If you have any further thoughts, questions or concerns be sure to give us a call toll free at (888) 351-8781. We are always here to help.